Trioliet News for Eurotier 2012

Agro Napló
Automatic feeding system with feed bunkers - Triomatic T30 Straw blower with dust control Solomix 2 700 feeding system for Biogas digester

 

Automatic feeding system with feed bunkers - Triomatic T30

 

Every dairy farmer would like to feed his animals better and more effectively. Many research results support that more frequent feeding results in higher feed intake and higher production. On top op that, it improves the cow’s health, condition and lifetime.

 

This is a fine and useful theory, but usually the labour involved is the limiting factor to  implement it. Triomatic, the automatic feeding system of Trioliet, now enables you to make this wish come true without having to sacrifice any more of your precious time. The Trioliet automatic feeding system also improves your milking robot’s milking frequency because fresh feed has a positive influence on cow traffic.

 

 


 

 



At the Triomatic T30 feeding system, the feed kitchen consists of several feed bunkers that stock each type of feed for one or two days. The Triomatic T30 bunkers can be loaded easily with a loading gear. The feed will be transported by the bottom chain, by the angle and the 2 dispenser rollers, the amount of feed discharged into the robot will be controlled accurate. The feed need to be easy to loosen up, it has to be cut/chopped in a maximum length of 15cm.



The second component is the feeding robot, in fact a small diet feeder cart with vertical mixing augers that moves independently through the stable, suspended on an overhead track powered by an electric power supply rail. The system mixes and distributes the feed. The Triomatic T30 bunker is easy to load with a loading gear / silage grap, it need to be done once a day or two days, appending on the feed and weather circumstances. The loose and cut/chopped feed (max. length 15cm) will be loaded on the horizontal part of the T30 bunker.



With a loading gear / silage grap attached to a wheel loader or tractor with frontloader, the T30 bunker can be loaded with approx. 18m 3 feed. Even the T30 bunker can be loaded again while it is not empty, because of the horizontal part. The feed will be transported by the bottom chain, the steep angled part will take care not too much feed in the same time will come to the top. The dispenser rollers will take care of an accurate loading of the feed robot.

 

 


 

 



A process computer controls the entire feeding process. In a conveniently arranged programme you enter all rations, feeding frequencies, feeding times and group classifications. The machine carries out your instructions line by line and, if required, exactly reports back to your feed management system or to your nutritionist what has been fed. Communication with (feed) management software on your home PC is easy.



With the Triomatic T30 automatic feeding system it’s possible to:

1. Increase milk yield up to 10%

2. Increase feed efficiency up to 20%

3. Save labour up to 80%

4. Increase flexibility in time and quality of life

5. Save on construction costs because of narrow feed alley

6. Save on energy up to 60%

7. Increase animal welfare and improve health.

 MORE INFO

 

 

Straw blower with dust control



Every farmer wants the best for his animals. The health as well as the comfort of the cattle are important factors when choosing farm machinery. Also when choosing diet feeders and bedding equipment. Trioliet now has its Solomix P range, diet feeder with straw blower, optionally equipped with a dust control system. Water sprinklers ensures less dust when operated. Not only the animals benefit, but also the farmer himself. The water decreases dust and microorganisms floating around and is therefore more hygienic.

 

 


 

 



The Solomix P can blow up to 25 meters deep. Normally a lot of dust is flying around in the barn, but with dust control that belongs to the past. The water spray nozzle bank is installed in the blower housing and the reservoir is mounted at the front of the machine, easy accessible. The water tank has a capacity of 100 litres. In addition, the system can be easily operated from the tractor seat. So Solomix P with dust control for better health of animals and humans!

MORE INFO

 

 




 

 

 

Solomix 2 700 feeding system for Biogas digester



For small biogas installations up to 75 kW Trioliet developed a biogas feeding system, derived from the known stationary mixers with two vertical augers. The special feature of this mixer is a multi-stage bottom in the mixing chamber. One auger is situated "deeper" than the other auger. This creates an opening in which a horizontal screw conveyor or other feeding system can be installed. Thanks to this construction the lower mixing auger can fill up the screw conveyor optimally with organic material such as manure, silage and other long fibrous residues that usual are difficult to dispense. Blockage due to accumulation is excluded.



Thanks to the small diameter of the augers low power is required (up to 7.5 and 5.5 kW for mixing). The control is simplified because there are no side discharge doors. Because of its elongated oval shape the machine is easy to fill with a front loader or shovel.

 

 

 

 

 



The system is available in two versions.



1. Cover injection system

The machine stands above the ground on top of the digester and dispenses directly into the digester. The system is further controlled as usual through the control of the biogas plant. The control is easy to operate and the system is suitable for all bio materials (also hard to discharge materials).



2. In combination with an injection system

From the mixing chamber the biomaterial is dispensed directly into the slurry stream by the injection screw. The biomaterial enriched with manure is then pumped into the digester. This system offers great advantages:



- There is no organic material (including any foreign objects) in the manure pump. Therefore the pump is spared. The system is (relatively) insensitive to stones or other

foreign objects.



- Most companies already use a slurry pump, so the system can be installed in the existing infrastructure without significant additional costs.



- It is a completely stand-alone system, possible to extend with controls, which (except

the piping) can be used without building constructions. On the PLC (with modem access and GSM alarm notification), the entire injection cycle can be programmed. The PLC controls, slurry pump, injection screw, mixer and all valves.

 




Specifications:

- Dimensions (LxWxH) = 3,75m x 1,93m x 2,15m (without Cover injection system / Injection screw)

- 5.5 and 7.5 kW Electro motors

- Walls of 4mm stainless steel. Wear ring and bottom of 8mm stainless steel.

- Mixing augers: Stainless steel 8 mm

- Capacity: 7m³

 

 



Options:

- Weighing system (possibly with feed management software)

- Cover injection system

- Injection system

- Automatic operation (Stand-alone system)

Címlapkép: Getty Images
CÍMLAPRÓL AJÁNLJUK
KONFERENCIA
AgroFuture 2024
Új rendezvény a fenntarthatósági követelményeről és innovációs lehetőségekről!
AgroFood 2024
Országos jelentőségű rendezvény az élelmiszeripari vállalkozások számára!
Vállalati Energiamenedzsment 2024
Tudatos vállalati energiamenedzsment a hazai cégeknek!
Agrárium 2024
Jön a tavasz kiemelkedő agráripari konferenciája!